DTC Confirmation Procedure
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC CONFIRMATION PROCEDURE ".
The following DTCs are not detected: MAF sensor, IAT sensor, VSS and ECT sensor (other than DTC P0116)
The following DTCs are not detected: MAF sensor, IAT sensor, VSS and ECT sensor (other than DTC P0116)
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch, clear DTC if any.
- Drive vehicle more than 37 mph (60 km/h) for more than 10 minutes.
- Stop vehicle.
- Check DTC and pending DTC by using scan tool.