LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Grand Vitara Premium, RWD, Standard >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Brakes - Esp >> Diagnostic Information And Procedure >> DTC U1126: Lost Communication With Steering Angle Sensor (Reception Error) >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "Electronic Stability Program Check" performed?  Go to Step 2. Go to ELECTRONIC STABILITY PROGRAM CHECK .
2  DTC check for ESP® 
  1. Check DTC for ESP®.

Is DTC U1126 and DTC U1073 detected together? 		 Go to DTC U1073: CONTROL MODULE COMMUNICATION BUS OFF  for troubleshooting. Go to Step 3.
3  Check each control module connectors 
  1. Check connection of connectors of all control modules communicating by means of CAN.
  2. Check DTC for ESP®.

Is DTC U1126 detected? 		 Go to Step 4. Check for intermittent trouble referring to INTERMITTENT AND POOR CONNECTION INSPECTION .
4  CAN communication circuit check 
  1. Turn ignition switch to OFF position.
  2. Disconnect connectors of ESP® control module and steering angle sensor communicating by means of CAN.

Is each CAN communication circuit between ESP® control module and steering angle sensor opened, shorted or high resistance? 		 Repair or replace the CAN communication line. Go to Step 5.
5  DTC check for ESP® 
  1. Turn ignition switch to OFF position.
  2. Disconnect connectors of all control modules communicating by means of CAN.
  3. Connect connectors to ESP® control module and steering angle sensor.
  4. Check DTC for ESP®.

Is DTC U1126 detected? 		 Go to Step 6. Go to Step 7.
6  Check steering angle sensor 
  1. Turn ignition switch to OFF position.
  2. Check steering angle sensor power and ground circuit.
  3. If OK, then substitute a known-good steering angle sensor.
  4. Connect connectors of disconnected control modules communicating by means of CAN.
  5. Calibrate steering angle sensor referring to SENSOR CALIBRATION .
  6. Clear all DTC(s) and check DTC for ESP®.

Is DTC U1126 detected? 		 Check ESP® power and ground circuit. If circuit is OK, substitute a known-good ESP® hydraulic unit/control module assembly and check DTC. Steering angle sensor was malfunction.
7  CAN communication circuit check 
  1. Turn ignition switch to OFF position.

Is each CAN communication circuit between disconnected control modules (other than ESP® control module and steering angle sensor) opened, shorted or high resistance? 		 Repair or replace the CAN communication line. Go to Step 8.
8  DTC check for ESP® 
  1. Connect connectors of disconnected control modules communicating by means of CAN.
  2. Disconnect each connector.
    • ECM
    • TCM (for A/T model)
    • BCM
    • 4WD control module (if equipped)
    • Keyless start control module (if equipped)
    • Steering angle sensor
  3. Check DTC for ESP®.

Is DTC U1126 detected? 		 Check ESP® control module power and ground circuit. If circuits are OK, substitute a known-good ESP® hydraulic unit/control module assembly and check DTC. Check applicable control module power and ground circuit. If circuit is OK, substitute a known-good applicable control module and check DTC.
scientia non olet · About LEMON Manuals