LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Grand Vitara Premium, RWD, Standard >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Brakes - Esp >> Diagnostic Information And Procedure >> DTC C1050: Back Switch Failure >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC TROUBLESHOOTING CHART

Step Action YES NO
Was "Electronic Stability Program Check" performed?  Go to Step 2. Go to ELECTRONIC STABILITY PROGRAM CHECK .
Check back up light switch and its circuit 
  1. Turn ignition switch to ON position.
  2. Check back-up lights, back up light switch and their circuit check. Refer to EXTERIOR LIGHTS .

Are they in good condition? 
Go to Step 3. Repair or replace.
Check back up light switch circuit 
  1. Turn ignition switch to OFF position.
  2. Disconnect ESP® control module connector.
  3. Check for proper connection to ESP® control module connector terminal at "E53-10".
  4. If OK, then measure voltage between connector terminal "E53-10" and vehicle body ground.

Is it 0 V? 
Go to Step 4. "RED" wire circuit is shorted to power circuit.
Check back up light switch circuit 
  1. Turn ignition switch to ON position.
  2. Measure voltage between connector terminal "E53-10" and vehicle body ground with the shift lever in "Reverse" position.

Is it 10 - 14 V? 
Substitute a known-good ESP® hydraulic unit/control module assembly and check DTC. "RED" wire circuit open.