LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Grand Vitara Premium, RWD, Standard >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Brakes - Esp >> Diagnostic Information And Procedure >> DTC C1037: Steering Angle Sensor Power Supply Failure >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "Electronic Stability Program Check" performed?  Go to Step 2 Go to ELECTRONIC STABILITY PROGRAM CHECK .
2  Check steering angle sensor power supply circuit 
  1. Check circuit fuses for steering angle sensor and its circuit.

Is it good condition? 		 Go to Step 3. Replace fuse and check for short circuit to ground.
3  Check steering angle sensor power supply circuit 
  1. Turn ignition switch to OFF position.
  2. Disconnect steering angle sensor connector.
  3. Check for proper connection to steering angle sensor connector terminals at "E45-1", "E45- 2" and "E45-3".
  4. If OK, then measure voltage between connector terminal "E45-3" and vehicle body ground.

Is it 10 - 14 V? 		 Go to Step 4. "WHT" wire circuit open.
4  Check steering angle sensor power supply circuit 
  1. Measure voltage between connector terminal "E45-1" and vehicle body ground with ignition switch turned ON.

Is it 10 - 14 V? 		 Go to Step 5. "GRN/ORN" wire circuit open.
5  Check steering angle sensor power supply circuit 
  1. Turn ignition switch to OFF position.
  2. Measure resistance between connector terminal "E45-2" and vehicle body ground.

Is resistance less than 2 Ω? 		 Go to Step 6. "BLK" wire circuit open or high resistance.
6  Check steering angle sensor 
  1. Connect steering angle sensor connector.
  2. Check steering angle sensor referring to STEERING ANGLE SENSOR ON-VEHICLE INSPECTION .

Is it good condition? 		 Substitute a known-good ESP® hydraulic unit/control module assembly and check DTC. Replace steering angle sensor.
scientia non olet · About LEMON Manuals