Brake Booster Removal And Installation: Installation

NOTE:

Check length of push rod clevis (2). Refer to BOOSTER PUSH ROD CLEVIS ADJUSTMENT .

Install gasket to booster and then install booster to dash panel as shown in figure. Then connect booster push rod clevis (2) to pedal arm (3) with clevis pin inserting from left (4) and clip (5).
Tighten booster attaching nuts (6) to the specified torque.
Tightening torque

Booster attaching nut a: 13 N.m (1.3 kg-m, 9.5 lb-ft)

Fig 1: Identifying Clevis Pin, Steering Column & Brake Pedal Arm
Courtesy of SUZUKI OF AMERICA CORP.
Connect brake vacuum hose to brake booster.
Install master cylinder referring to MASTER CYLINDER ASSEMBLY REMOVAL AND INSTALLATION .
After installing, fill reservoir with specified brake fluid and bleed brake system. Check each installed part for fluid leakage and perform brake test.