DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC CONFIRMATION PROCEDURE ".
- Intake air temperature: between -14 °C and 70 °C (6.8 °F and 158 °F).
- Engine coolant temperature: higher than 58 °C (136 °F).
- The following DTCs are not detected: A/F sensor, A/F sensor heater, HO2S-2 and HO2S-2 heater.
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Increase vehicle speed to 35 mph (56 km/h) or more.
- Keep above vehicle speed for 5 min. (Throttle valve operating is kept constant in this step).
- Increase vehicle speed to 50 - 60 mph (80 - 100 km/h). (engine speed; 2500 - 3000 RPM)
- Keep above vehicle speed for 5 min. (Throttle valve operating is kept constant in this step).
- Stop vehicle and check DTC and pending DTC by using scan tool.