DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC CONFIRMATION PROCEDURE ".
- Intake air temperature: higher than -10°C (14°F).
- Atmospheric pressure: higher than 75 kPa (560 mmHg) (Altitude: lower than 2790 m (9150 ft).
- The following DTCs are not detected: MAP sensor, IAT sensor, ECT sensor, EGR system, barometric pressure sensor and MAF sensor (other than P0101).
- With ignition switch OFF, connect scan tool.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Increase vehicle speed till engine speed is reached 1200 - 4800 r/min.
- Drive vehicle for 1 min. at engine speed 1200 - 4800 r/min.
- Stop vehicle and check DTC and pending DTC by using scan tool.