Steering Angle Sensor Calibration (Not Using SUZUKI Scan Tool)

CAUTION: When power is not supplied to the steering angle sensor by removing battery or fuse, steering angle sensor should be calibrated.

Set steering wheel in straight-ahead position.
Connect battery terminals and/or fuse and start engine.
CAUTION: When power is not supplied to the steering angle sensor by removing battery or fuse, DTC C1075 is detected and SLIP indicator lamp (1) flashes.
If DTC other than C1075 is detected, SLIP indicator lamp flushes and other indicator illuminate. In that case, repair the detected DTC first.

Fig 1: Identifying SLIP Indicator Lamp
Courtesy of SUZUKI OF AMERICA CORP.
Drive vehicle straight on level ground at 15 km/h (9.5 mph) or above for few seconds without spinning wheels. And confirm that SLIP indicator lamp is OFF.