Manual Road Test: Notes

This test checks the gears being used in "L", "3" or "D" range when driven with unoperated gear shift control system. Test drive vehicle on a level road.

1. With select lever in "P", start engine and warm it up.
2. After warming up engine, turn ignition switch OFF and disconnect valve body connector.
3. With select lever in "L" range, start vehicle. Check that 3rd gear is being used referring to V1000 table shown.
4. While vehicle is running, shift select lever to "3" range and check that 3rd gear is being used.
5. While vehicle is running, shift select lever to "D" range and check that 4th gear is being used.
6. After the checks, stop vehicle then turn ignition switch OFF, and connect valve body connector.
7. Clear DTC.

Vehicle speed per 1000 RPM in engine speed with transfer shift position in 4H