DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.
- Connect scan tool to DLC with ignition switch OFF.
- Clear DTCs in TCM and ECM memories by using scan tool.
- Start engine and warm it up to normal operating temperature.
- Shift select lever to "N" and "D" range for each 10 seconds.
- Drive vehicle with 5th in "D" range and lock-up ON for 20 seconds or longer referring to AUTOMATIC GEAR SHIFT TABLE .
- Drive vehicle with 2nd or 3rd gear in "D" range, 15 - 20% throttle opening and at vehicle speed of 40 km/h (25 mile/h).
- Stop vehicle and turn ignition switch OFF.
- Repeat Step 3) to 6) one time.
- Stop vehicle.
- Check DTC, pending DTC and freeze-frame data.