DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.

DTC TROUBLESHOOTING CHART

Step	Action	YES	NO
1	Was "A/T System Check" performed?	Go to Step 2.	Go to A/T SYSTEM CHECK .
2	Check input shaft speed sensor circuit Disconnect TCM connectors with ignition switch OFF. Check for proper connection to input shaft speed sensor at "E93-5" and "E93-14" terminals. If OK, check resistance of sensor circuit. Resistance of input shaft speed sensor circuit Between terminals "E93-5" and "E93-14" of disconnected harness side TCM connector: 560 - 680 Ω at 20°C (68°F) Between terminals "E93-14" of disconnected harness side TCM connector and ground: No continuity Are check results satisfactory?	Go to Step 4.	Go to Step 3.
3	Inspection output shaft speed sensor Inspect input shaft speed sensor referring to OUTPUT SHAFT SPEED SENSOR INSPECTION . Is check result satisfactory?	Output shaft speed sensor signal or ground circuit is malfunction.	Go to Step 4.
4	Check visually Output shaft speed sensor and sensor rotor using mirror for following No damage No foreign material attached Correct installation Courtesy of SUBARU OF AMERICA, INC. Are they in good condition?	Intermittent trouble. Check for intermittent trouble referring to INTERMITTENT AND POOR CONNECTION INSPECTION .	Clean, repair or replace.