Part Inspection and Correction Table

PART INSPECTION REFERENCE CHART

Part	Inspect for	Correction
Casted part, machined part	Small flaw, burr	Remove with oil stone.
Deep or grooved flaw		Replace part.
Clogged fluid passage		Clean with air or wire.
Flaw on installing surface, residual gasket		Remove with oil stone or replace part.
Crack		Replace part.
Bearing	Unsmooth rotation	Replace.
Streak, pitting, flaw, crack		Replace.
Bushing, thrust washer	Flaw, burr, wear, burning	Replace.
Oil seal, gasket	Flawed or hardened seal ring	Replace.
Worn seal ring on its periphery or side		Replace.
Piston seal ring, oil seal, gasket, etc.		Replace.
Gear	Flaw, burr	Replace.
Worn gear tooth		Replace.
Splined part	Burr, flaw, torsion	Correct with oil stone or replace.
Snap ring	Wear, flaw, distortion	Replace.
No interference		Replace.
Thread	Burr	Replace.
Damage		Replace.
Spring	Settling, sign of burning	Replace.
Clutch disc, brake disc	Wear, burning, distortion, damaged claw	Replace.
Clutch plate, brake plate	Wear, burning, distortion, damaged claw	Replace.
Sealing surface (where lip contacts)	Flaw, rough surface, stepped wear, foreign material	Replace.