Scan Tool Data: Notes
The parameter data below are values measured with the scan tool when the normally operating vehicle is under the following conditions. When taking measurements for comparison by using the scan tool, be sure to check that the vehicle is under the following conditions.
- Apply parking brake and block wheels.
- Ignition switch ON.
- Turn OFF air conditioning (if equipped).
- Set the wheel in straight-ahead position and hands off steering wheel.
- Turn OFF all electric loads (except ignition).
- Check that there is no DTC.
SCAN TOOL DATA
| Scan Tool Data | Standards | Condition |
|---|---|---|
| Battery Voltage | 10.0 - 16.0 V | - |
| Pump Motor Driver | 0.0 V | - |
| RF Wheel Speed | 0 km/h, 0.0 MPH | Vehicle is in stationary condition. |
| LF Wheel Speed | 0 km/h, 0.0 | MPH Vehicle is in stationary condition. |
| RR Wheel Speed | 0 km/h, 0.0 MPH | Vehicle is in stationary condition. |
| LR Wheel Speed | 0 km/h, 0.0 MPH | Vehicle is in stationary condition. |
| Brake Switch | ON | Brake pedal is depressed |
| OFF | Brake pedal is released | |
| G sensor | 0 ± 0.1 G | Vehicle is on the level |
| Master Cyl Press | 0 ± 0.8 MPa | Brake pedal is released |
| G Sensor (lateral) | 0 ± 0.1 G | Vehicle is on the level |
| Yaw rate sensor | 0 ± 4 Deg/s | Vehicle is on the level |
| Steering angle Sen | 0 ± 3° | Front wheels are in straight-ahead position |
| Stability control | INACTIVE | Stability control system is not working |
| TCS control (brake) | INACTIVE | Brake function by TCS is not working |
| TCS control (engine) | INACTIVE | Torque control by TCS is not working |
| ESP® off state (cont) | ESP® ON | ESP® OFF switch is OFF condition |
| ESP® OFF | ESP® OFF switch is ON condition | |
| Steering angle Sen | Neutral | Front wheels are in straight-ahead position |