Output Shaft Disassembly and Assembly

Output Shaft Disassembly and Assembly
Disassembly
1. Remove output shaft rear snap ring.
2. Apply bearing puller to output shaft front bearing (1), and drive out output shaft front bearing, output shaft gear (2) and output shaft rear bearing (3) all at once from output shaft using press.





Assembly
1. Clean all components thoroughly, inspect them for any abnormality and replace with new ones as necessary.
2. Put front bearing (1) onto output shaft facing groove (4) side to output shaft gear (2) and drive in output shaft front bearing, output shaft gear and output shaft rear bearing (3) all together using special tool and hammer.

Special Tool (A): 09940-51710





3. Install new output shaft rear snap ring.