LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Forenza Premium, 4D Wagon, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Performance - DTC P0016 - P0141 >> DTC P0141: HO2S Heater Performance Sensor 2 >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0141: HO2S Heater Performance Sensor 2: Troubleshooting

TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Was the check performed?		 - Go to Step 2 Go to On-Board Diagnostic (OBD II) System Check
2
  1. Turn the ignition OFF.
  2. Disconnect the HO2S2 connector.
  3. Turn the ignition ON.
  4. Using a voltmeter, measure the voltage at terminal 2 of HO2S2 and ground.

Is the voltage within the specified value?		 11 - 14 V Go to Step 3 -
3
  1. Turn the ignition OFF.
  2. Disconnect the HO2S2 connector.
  3. Check the connections at HO2S2 connector, terminal 3 and 1 and repair as needed.

Is the repair complete?		 - Go to Step 10 Go to Step 4
4 Disconnect the Engine Control Module (ECM) connector.
Check the connection at the ECM connector, terminal C57 and repair as needed.		 - Go to Step 10 Go to Step 5
5
  1. Using ohmmeter, measure the resistance between terminal 4 of the HO2S2 and terminal C57 of the ECM.

Is the resistance equal to the specified value?
  1. Using a voltmeter, measure the voltage between terminal C57 of the ECM and ground.

Is the voltage within the specified value?		 0 Ω≈ 0 V Go to Step 7 Go to Step 6
6 Repair an open or short to voltage circuit.
Is the repair complete?		 - Go to Step 10 -
7 Check he continuity between terminal 4 and 2 of the HO2S2.
Is a problem found?		 - Go to Step 8 Go to Step 9
8
  1. Turn the ignition OFF.
  2. Replace the HO2S2.

Is the repair complete?		 - Go to Step 10 -
9
  1. Turn the ignition OFF.
  2. Replace the ECM.

Is the repair complete?		 - Go to Step 10 -
10
  1. Using the scan tool, clear the Diagnostic Trouble Codes (DTCs).
  2. Start the engine and idle at normal operating temperature.
  3. Operate the vehicle within the Conditions for setting this DTC as specified in the supporting text.

Does the scan tool indicate that this diagnostic has run and passed?		 - Go to Step 11 Go to Step 2
11 Check if any additional DTCs are set.
Are any DTCs displayed that have not been diagnosed?		 - Go to applicable DTC table System OK
scientia non olet · About LEMON Manuals