LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Forenza Base, 4D Wagon, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> Engine Control Systems >> Engine Performance - DTC P1391 - P2610, DTC U0073 >> DTC P2282: Intake Manifold Air Leak >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P2282: Intake Manifold Air Leak: Troubleshooting

TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Is the system check complete?
- Go to Step 2 Go to On-Board Diagnostic (OBD II) System Check
2 Does the scan tool display any other DTCs set? - Go to applicable DTC table Go to Step 3
3
  1. Observe the Freeze Frame and/or the Failure Records data for this DTC.
  2. Turn the ignition OFF for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Setting the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.

Did the DTC fail this ignition?
- Go to Step 4 -
4
  1. Turn the ignition OFF.
  2. Repair the air leak in one or more of the following components:
    • The air induction system after the MAP sensor
    • The intake gaskets
    • The EGR gaskets

Did you complete the repair?
- Go to Step 5 -
5
  1. Clear the DTCs with a scan tool.
  2. Turn the ignition OFF for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Setting the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.

Did the DTC fail this ignition?
- Go to Step 2 Go to Step 6
6 Are there any DTCs that have not been diagnosed? - Go to applicable DTC table System OK