LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Forenza Base, 4D Sedan, Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning System >> Repair Instructions >> Shaft Seal Replacement >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Shaft Seal Replacement: Notes

CAUTION: A shaft seal should not be replaced because a small amount of oil is found on the adjacent surface. The seal is designed to leak some oil for lubrication purposes. A shaft seal should be changed only when a large amount of sprayed oil is found and then only after actual refrigerant leakage is found by using an approved leak detection procedure. Refer to Leak Testing Refrigerant System .

Should a compressor shaft seal ever have to be replaced, the receiver-dryer in this system must also be removed from the vehicle. The oil in the receiver-dryer must then be drained, measured and replaced. Refer to Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System .

Tools Required: 

J-5403 Snap Ring Pliers 

J-9553-1 O-ring Remover 

J-23128-A Seal Seat Remover/Installer 

J-33011 O-ring Installer 

J-34614 Shaft Seal Protector 

scientia non olet · About LEMON Manuals