Starter Removal and Installation: Installation
- Place the starter assembly in position using an assistant to prop up the starter to aid in screwing in the upper stud with the weld nut.
- Install the starter mounting bolts.
Tighten:
Tighten the starter-to-engine block mounting bolt to 21 N.m (15 lb-ft) and the starter-to-engine transaxle mounting bolt to 21 N.m (15 lb-ft).
See Figure.
- Position the starter electrical wire on the solenoid terminals and the ground wire on the lower stud.
- Install the starter solenoid nuts and the ground wire nut.
Tighten:
- Tighten the starter solenoid terminal-to-battery cable terminal nut to 12 N.m (106 lb-in), and the starter solenoid terminal-to-ignition solenoid terminal nut to 6 N.m (53 lb-in).
- Tighten the starter lower mounting stud ground wire nut to 12 N.m (106 lb-in).
See Figure.