TPMS Reminder Reset - Procedure 05
NOTE:
If spare tire has been used, or if a wheel or tire pressure sensor has been replaced, the tire pressure sensors must be registered.
NOTE:
In high altitude areas, the warning light may not turn off even after adjusting tire pressures. In this case, adjust inflation pressure to a slightly higher pressure than specified.
- Install the TPMS transmitters to the vehicle.
- Connect the scan tool with ALDL connector.
- Turn the Ignition switch to ON.
- Go to the ID resister mode of the scan tool.
- Contact the LF tool on the air valve and push the LF tool button for 4 seconds, and you can see the TPMS warning lamp blinks. Also you can see the ID on the scan tool screen.
- Repeat step 5 for 4 tires respectively within 5 minutes.NOTE: In case of tire replacement or rotation, the ID registration should be performed for 4 tires.