Diagnostic Aids
NOTE:
After repairs, use the scan tool Fuel Trim Reset function to reset the long-term fuel trim to 128 (0%).
Check for poor connection at the ECM. Inspect the harness connectors for the following conditions:
- Backed-out terminals
- Improper mating
- Broken locks
- Improperly formed
- Damaged terminals
- Poor terminal-to-wire connection
Inspect the wiring harness for damage. If the harness appears to be OK, observe the HO2S1 display on the scan tool while moving the connectors and the wiring harness related to the engine harness. A change in the display will indicate the location of the fault.
If a DTC P042E is also set, check the 5 volt reference circuits for a short to voltage.
Check for a restricted exhaust system.
A shorted 5 volt reference circuit may cause a DTC P0172 to set. Check the 5 volt reference sensors for abnormal readings.