ABS Hydraulic Unit / Control Module Assembly Removal and Installation: Removal

NOTE: Before removal, inspect the parts referring to ABS HYDRAULIC UNIT / CONTROL MODULE ASSEMBLY ON-VEHICLE INSPECTION .

Disconnect negative cable from battery.
Disconnect ABS hydraulic unit / control module assembly connector (1) by pull down the lock (2).

Fig 1: Disconnecting ABS Hydraulic Unit / Control Module Assembly Connector
Courtesy of SUZUKI OF AMERICA CORP.
Using special tool, loosen flare nuts (1) and disconnect brake pipes (2) from ABS hydraulic unit / control module assembly (3).
Special Tool
1. 09950-78220
  NOTE: Put bleeder plug cap or the like onto pipe to prevent fluid from spilling. Do not allow brake fluid to get on painted surfaces.
  
  Fig 2: Disconnecting Brake Pipes
  Courtesy of SUZUKI OF AMERICA CORP.
Remove three bolts and disconnect take out ABS hydraulic unit / control module assembly (1) from bracket using flat end rod or the like (2).
CAUTION:
- Do not give an impact to hydraulic unit.
- Use care not to allow dust to enter hydraulic unit.
- Do not place hydraulic unit on its side or upside down. Handling it in inappropriate way will affect its original performance.
  
  Fig 3: Disconnecting ABS Hydraulic Unit / Control Module Assembly From Bracket
  Courtesy of SUZUKI OF AMERICA CORP.