DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temp.: between -10°C and 60°C (14°F and 140°F)
- Altitude (barometric pressure): 2500 m, 8202 ft or less (560 mmHg, 75 kPa or more)
- With ignition switch turned OFF, connect scan tool.
- Turn ON ignition switch and clear DTC using scan tool.
- Start engine and warm up to normal operating temperature.
- Increase vehicle speed till engine speed is higher than 1500 r/min.
- Operate vehicle within freeze frame data condition as noted for 5 min.
- Stop vehicle and check DTC and pending DTC.