DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester.
- Turn OFF ignition switch and connect scan tool to DLC.
- Clear DTC with ignition switch turned ON.
- Start engine and shift select lever to "D" range.
- Increase vehicle speed to higher than 25 mph, 40 km/h and then stop vehicle.
- Repeat step 4 nine times.
- Shift selector lever to "2" range and repeat Step 4 and 5.
- Shift selector lever to "L" range and repeat Step 4 and 5.
- Check DTC and pending DTC.