LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2006 >> Aerio Base, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Diagnostic Information and Procedures >> Cruise Control Module and Its Circuit Inspection >> Resistance Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Resistance Check

  1. Disconnect cruise control module connector from cruise control module with ignition switch OFF.
    CAUTION:
    • Never touch terminals of cruise control module itself.
    • Be sure to turn OFF ignition switch for this check.
    • Resistance in the following table represents that when parts temperature is 20 °C (68 °F).
    Fig 1: Checking Resistance
    G04591786Courtesy of SUZUKI OF AMERICA CORP.
  2. Check resistance between each pair of terminals of disconnected connectors as shown in the following table.
    TERMINAL WIRE CIRCUIT CONDITION REFERENCE

    Terminals Circuit Standard Resistance Condition
    E52-11 - body ground Ground Continuity -
    E52-6 - E52-12 Brake pedal position switch in stop lamp switch Continuity Brake pedal released.
    No continuity Brake pedal depressed.
    E52-8 - E52-5 CANCEL switch No continuity CANCEL switch OFF (released).
    Continuity CANCEL switch ON (pressed).
    SET/COAST switch No continuity SET/COAST switch OFF (released).
    200 - 240 Ω SET/COAST switch ON (moved down).
    RESUME/ACCEL switch No continuity RESUME/ACCEL switch OFF (released).
    820 - 1000 Ω RESUME/ACCEL switch ON (moved up).
    E52-9 - E52-11 (M/T) Clutch pedal position switch (M/T only) No continuity Clutch pedal released.
    Continuity Clutch pedal depressed fully.
    E52-9 - E52-11 (A/T) Transmission range switch (Park / neutral position switch) (A/T only) Continuity Selector lever in "P" or "N" range.
    No continuity Selector lever in "R", "D", "2" or "L" range.
scientia non olet · About LEMON Manuals