Connector: G04
CONNECTOR SPECIFICATION
| Terminal | Wire color | Circuit |
|---|---|---|
| 1 | - | - |
| 2 | - | - |
| 3 | BRN | Radiator fan control relay-1 output |
| 4 | GRN/RED | Radiator fan control relay-2 output |
| 5 | BLU/WHT | EVAP canister vent valve output |
| 6 | BLK/RED | Main power supply |
| 7 | BLK/RED | Main power supply |
| 8 | - | - |
| 9 | GRN/ORN | Engine coolant temp. signal for combination meter |
| 10 | LT GRN/BLK | Ignition pulse signal (engine revolution signal) for combination meter |
| 11 | BLU/ORN | A/C refrigerant pressure switch (if equipped) |
| 12 | GRN/BLK | A/C switch (if equipped) |
| 13 | PPL/YEL | MIL |
| 14 | YEL/BLK | Electrical load signal for rear defogger and clearance lamp |
| 15 | ORN | Ground for sensors |
| 16 | - | - |
| 17 | YEL | Fuel level sensor signal |
| 18 | LT GRN | EVAP leak detection pump output (if equipped) |
| 19 | RED/YEL | EVAP leak check pressure sensor signal (if equipped) |
| 20 | GRY/BLK | Engine coolant temp. signal for TCM (A/T) |
| 21 | GRN/YEL | Serial communication line for TCM (A/T) |
| 22 | GRY/BLU | Park/neutral position signal (A/T) |
| 23 | - | - |
| 24 | BLU/BLK | Electrical load signal for heater blower motor |
| 25 | WHT/RED | Power source for ECM internal memory |
| 26 | WHT/BLK | A/C evaporator outlet temperature sensor signal (if equipped) |
| 27 | GRY/RED | Output of 5 V power source for EVAP leak check pressure (if equipped) |
| 28 | RED/WHT | Engine torque signal for TCM (A/T) |
| 29 | LT GRN/RED | Torque reduction signal for TCM (A/T) |
| 30 | PPL/WHT | Throttle opening signal for TCM (A/T) |
| 31 | BLU | Serial communication line of data link connector 12 V |
| 32 | - | - |
| 33 | - | - |
| 34 | YEL/WHT | A/C evaporator inlet temperature sensor signal (if equipped) |
| 35 | PPL | Vehicle speed sensor signal |