Deployed Air Bag (Inflator) Module Disposal

WARNING: Failure to follow proper air bag (inflator) module disposal procedures can result in air bag deployment which may cause personal injury. The undeployed air bag (inflator) module must not be disposed of through normal refuse channels. The undeployed air bag (inflator) module contains substances that can cause severe illness or personal injury if the sealed container is damaged during disposal.

Deployed air bag (inflator) module can be disposed of through normal refuse channels just like any other parts. For their disposal, however, the following points should be noted.

The air bag (inflator) module immediately after deployment is very hot. Wait for 30 minutes to cool it off before handling it.
Never apply water, oil, etc. to deployed air bag (inflator) module to cool it off and be careful so that water, oil etc. does not get on the deployed air bag (inflator) module.

Fig 1: Warning Never Apply Water, Oil To Deployed Air Bag (Inflator) Module To Cool Off
Courtesy of SUZUKI OF AMERICA CORP.
After the air bag (inflator) module has been deployed, the surface of the air bag may contain a powdery residue. This powder consists primarily of cornstarch (used to lubricate the bag as it inflates) and by-products of the chemical reaction. As with many service procedures, you should wear gloves and safety glasses.
When disposing of the deployed air bag (inflator) module, be sure to seal it in a vinyl bag.

Fig 2: Disposing Deployed Air Bag (Inflator) Module
Courtesy of SUZUKI OF AMERICA CORP.
When air bag (inflator) module have been deployed inside the vehicle which is going to be scrapped, leave them as installed to the vehicle.
Be sure to wash your hands with mild soap and water after handling them.