LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> XL-7 EX, RWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> 4A/T >> Diagnostic Information and Procedures >> DTC P0717: Input/Turbine Speed Sensor Circuit No Signal >> DTC Confirmation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Procedure

WARNING:
  • When performing a road test, select a place where there is no traffic or possibility of a traffic accident and be very careful during testing to avoid occurrence of an accident.
  • Road test should be carried out with 2 persons, a driver and a tester, on a level road.
  1. Connect scan tool to DLC with ignition switch OFF.
  2. Clear DTC, pending DTC and freeze frame data by using scan tool.
  3. Start engine and turn O/D cut switch ON.
  4. Shift select lever to "D" range and start vehicle.
  5. Keep vehicle speed at higher than 10 km/h (7 mile/h) with 1st gear in "D" range for 2 sec. or more.
  6. Increase vehicle speed and keep it at higher than 20 km/h (13 mile/h) with 2nd gear in "D" range for 2 sec. or more.
  7. Increase vehicle speed and keep it at higher than 30 km/h (20 mile/h) with 3rd gear in "D" range for 2 sec. or more.
  8. Stop vehicle.
  9. Check pending DTC and DTC.
scientia non olet · About LEMON Manuals