LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> XL-7 EX, RWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Repair Instructions >> Fuel Tank Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Tank Removal and Installation: Removal

  1. Relieve fuel pressure in fuel feed line referring to "FUEL PRESSURE RELIEF PROCEDURE ".
    CAUTION: This work must not be done when engine is hot. If done so, it may cause adverse effect to catalyst.
  2. Disconnect negative cable at battery.
  3. Insert hose of a hand operated pump (3) into fuel filler hose (1) and drain fuel in space "A" in the figure (drain fuel through it till fuel stops).
    CAUTION: Do not force hose of a hand operated pump into fuel tank. Doing so can damage fuel tank inlet (check) valve (2).
    Fig 1: Inserting Hose Of Hand Operated Pump Into Fuel Filler Hose
    G04098172Courtesy of SUZUKI OF AMERICA CORP.
  4. Remove fuel tank filler hose protector. Disconnect filler hose (3) from fuel tank (1) and recirculation hose (2) from fuel filler neck.
    Fig 2: Removing Fuel Tank Filler Hose Protector
    G04098173Courtesy of SUZUKI OF AMERICA CORP.
  5. Drain fuel tank by pumping fuel out through fuel tank filler. Use hand operated pump device to drain fuel tank.
    CAUTION:
    • Do not force of a hand operated pump (2) into fuel tank. Doing so can damage fuel tank inlet (check) valve (1).
    • Never drain or store fuel in an open container due to possibility of fire or explosion.
    Fig 3: Draining Fuel Tank By Pumping Fuel Out Through Fuel Tank Filler
    G04098174Courtesy of SUZUKI OF AMERICA CORP.
  6. Disconnect fuel filter inlet hose (3) from filter (1) referring to "FUEL FILTER REMOVAL AND INSTALLATION ".
    Fig 4: Disconnecting Fuel Filter Inlet Hose From Filter
    G04098175Courtesy of SUZUKI OF AMERICA CORP.
  7. Disconnect fuel check valve hose (1), return hose (2) and vapor control outlet hose (3) from pipes.

    For quick joint (H27 engine only), refer to "FUEL PIPE REMOVAL AND INSTALLATION ".

    Fig 5: Disconnecting Fuel Check Valve Hose Return Hose And Vapor Control Outlet Hose From Pipes
    G04098176Courtesy of SUZUKI OF AMERICA CORP.
  8. Remove fuel tank protector from vehicle.
  9. Lower fuel tank gradually while holding it horizontally and pull out each coupler from fuel pump (1) and fuel tank pressure (and temp.) sensor (2) (H25 engine only).
Fig 6: Pulling Out Each Coupler From Fuel Pump And Fuel Tank Pressure (And Temp.) Sensor
G04098177Courtesy of SUZUKI OF AMERICA CORP.