LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> XL-7 EX, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> H25 Engine >> Diagnostic Information and Procedures >> Fail-Safe Table
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fail-Safe Table

When any of the following DTCs is detected, ECM enters fail-safe mode as long as malfunction continues to exist but that mode is canceled when ECM detects normal condition after that.

FAIL-SAFE TABLE

DTC No. Trouble area Fail-safe operation Fail-safe mode reactivation condition
P0102
P0103		 MAF SENSOR Injector drive time (fuel injection volume) is determined according to throttle valve operating (idle position or not). Detected value of MAF sensor output voltage is 0.3 V min. and 5.0 V max.
P0112
P0113		 IAT SENSOR ENGINE control is performed on the basis of 40 °C intake air temp. Detected value of IAT sensor output voltage is 0.16 V min. and 5.00 V max.
P0117
P0118		 ECT SENSOR
  • ENGINE control is performed on the basis of 80 °C engine coolant temp.
  • A/T control is performed on the basis of 31 °C engine coolant temp.
 Detected value of ECT sensor output voltage is 0.16 V min. and 5.00 V max.
P0122
P0123		 TP SENSOR
  • ENGINE control is performed on the basis of 8 deg. throttle opening.
  • A/T control is performed on the basis of 0% throttle position.
 Detected value of TP sensor output voltage is 0.10 V min. and 4.80 V max.
P0500 VEHICLE SPEED SENSOR ENGINE control is performed on the basis of 10 km/h vehicle speed. And air flow at I AC valve is limited. Vehicle speed sensor signal is detected.
P0705
P0707		 TR SWITCH A/T control is performed in priority order of L, 2, N, D and R when more than one of R, D, N, 2 and L signals are inputted simultaneously. Single signal is inputted
P0722 OUTPUT SPEED SENSOR CIRCUIT NO SIGNAL A/T control is performed by using signal from VSS. Detected vehicle speed signal is 10 km/ h (6 mph) or more
P0973
P0974		 SHIFT SOLENOID A (#1) SHIFT SOLENOID #1: OFF SHIFT SOLENOID #2: ON TCC SOLENOID: OFF Monitor signal ON is detected when solenoid A (#1) is ON and monitor signal OFF is detected when it is OFF.
P0976
P0977		 SHIFT SOLENOID B (#2) SHIFT SOLENOID #1: OFF SHIFT SOLENOID #2: OFF TCC SOLENOID: OFF Monitor signal ON is detected when solenoid B (#2) is ON and monitor signal OFF is detected when it is OFF.
P2769
P2770		 TCC (LOCK-UP) SOLENOID TCC (Lock-up) solenoid OFF Monitor signal ON is detected when TCC control solenoid is ON and monitor signal OFF is detected when it is OFF.
scientia non olet · About LEMON Manuals