DTC Confirmation Procedure
WARNING:
- When performing a road test, select a place where is no traffic or possibility of a traffic accident and very careful during testing to avoid occurrence of an accident.
- Road test should be carried out with 2 persons, a driver and a tester, on a level road.
NOTE:
Check to make sure that the following conditions are satisfied when using this "DTC Confirmation Procedure".
- Intake air temperature: -14 °C (6.8 °) or higher
- Atmospheric pressure: higher than 560 mmHg (Altitude: lower than 2790 m (9150 ft))
- With ignition switch OFF, connect scan tool to DLC.
- Turn ON ignition switch and clear DTC by using scan tool if any.
- Start engine and warm up to normal operating temperature.
- Run engine at idle speed for 1 min. or more.
- Check DTC and pending DTC by using scan tool.