Resistance Check
- Disconnect cruise control module connector from cruise control module with ignition switch OFF.CAUTION:
- Never touch terminals of cruise control module itself.
- Be sure to turn OFF ignition switch for this check.
- Resistance in the following table represents that when parts temperature is 20 °C (68 °).
- Check resistance between each pair of terminals of disconnected connectors as shown in the following table.
TERMINALS RESISTANCE REFERENCE
| Terminals | Circuit | Standard Resistance | Condition |
|---|---|---|---|
| E132-11 -body ground | Ground | Continuity | - |
| E132-6-E132-12 | Brake pedal position switch in brake light switch | Continuity | Brake pedal released. |
| No continuity | Brake pedal depressed. | ||
| E132-8-E132-5 | CANCEL switch | No continuity | CANCEL switch OFF (released). |
| Continuity | CANCEL switch ON (pressed). | ||
| SET/COAST switch | No continuity | SET/COAST switch OFF (released). | |
| 200 - 240 ohm | SET/COAST switch ON (rotated). | ||
| RES/ACC switch | No continuity | RES/ACC switch OFF (released). | |
| 820 -1000 ohm | RES/ACC switch ON (rotated). | ||
| E132-9-E132-11 (M/T) | Clutch pedal position switch (M/T only) | No continuity | Clutch pedal released. |
| Continuity | Clutch pedal depressed fully. | ||
| E132-9-E132-11 (A/T) | Transmission range sensor (switch) (Park / neutral position switch) (A/ T only) | Continuity | Selector lever in "P" or "N" range. |
| No continuity | Selector lever in "R", "D", "2" or "L" range (for 4 A/T model) or "R", "D", "3" or "L" range (for 5 A/T model). |