Reading DTC Using "O/D OFF" Lamp

Turn ignition switch OFF.
Remove steering column hole cover (1).
Using service wire, connect diagnosis switch terminal (3) of monitor connector (2) to ground terminal (4).

Fig 1: Identifying Diagnosis Switch Terminal Of Monitor Connector
Courtesy of SUZUKI OF AMERICA CORP.
Turn ignition switch ON.
Read flashing pattern of "O/D OFF" lamp which represents DTC as shown in example below and write it down.

Fig 2: Identifying Flashing Pattern Of "O/D OFF" Lamp
Courtesy of SUZUKI OF AMERICA CORP.
After completing the check, turn ignition switch OFF and disconnect service wire from monitor connector.