LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Verona S >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Diagnostic Information and Procedures >> DTC P1841 EDS 3 Output Open >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC P1841 TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Is the check completed?		 - Go to Step 2. Go to "ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK ".
2
  1. Install the scan tool.
  2. Turn the ignition On, with the engine OFF.
  3. Select "Actuating" on the scan tool.
  4. Actuate the EDS 3 ON/OFF.

Does the EDS 3 change ON/OFF?		 ON/OFF Go to "DIAGNOSTIC AIDS ". Go to Step 3.
3
  1. Turn the ignition OFF.
  2. Disconnect the transaxle wiring connector.
  3. Measure the resistance between terminals 5 and 6 of the transaxle wiring connector.

Is the resistance within the values shown?		 TFT 25 °C (77 °F) 6 Go to Step 7. Go to Step 4.
4
  1. Remove the oil pan.
  2. Disconnect the wiring connector of the EDS 3.
  3. Measure the resistance between terminal 2 of the EDS 3 and terminal 5 of the transaxle connector.
  4. Measure the resistance between terminal 1 of the EDS 3 and terminal 6 of the transaxle connector.

Is the resistance within the values shown?		 - Go to Step 6. Go to Step 5.
5
  1. Repair the circuit (between terminal 2 and terminal 5) for an open.
  2. Repair the circuit (between terminal 1 and terminal 6) for an open.

Is the repair complete?		 - System OK -
6 Replace the EDS 3.
Is the replacement complete?		 - System OK -
7
  1. Disconnect the transaxle wiring connector and TCM connector.
  2. Measure the resistance between terminal 5 of the transaxle wiring connector and terminal C7 of the TCM wiring connector.
  3. Measure the resistance between terminal 6 of the transaxle wiring connector and terminal A11 of the TCM wiring connector.

Is the resistance within the values shown?		 = 0 Ω Go to Step 9. Go to Step 8.
8 Repair the transaxle wiring harness for an open.
Is the repair complete?		 - System OK -
9 Replace the TCM.
Is the replacement complete?		 - Go to Step 10. -
10
  1. After the repair, use a scan tool "clear info" function and road test the vehicle.
  2. Review the "DTC info".

Has the last test failed or is the current DTC displayed?		 - Begin diagnosis again. Repair verified exit DTC chart.
scientia non olet · About LEMON Manuals