Crossmember Assembly Installation

Install the control arm onto the crossmember assembly. Refer to this article.
Tighten

Tighten the stabilizer bar bolts and nuts to 50 N.m (37 lb-ft).
Install the crossmember bolts-to-control arm, nuts-to-longitudinal and crossmember.
Tighten

Tighten the crossmember bolts-to-control arm and nuts-to-longitudinal, to 150 N.m (110 lb-ft).

Fig 1: Installing Crossmember Bolts-To-Control Arm
Courtesy of SUZUKI OF AMERICA CORP.
Install the out tie rod and control arm ball joint. Refer to this article.

Fig 2: Installing Outer Tie Rod And Control Arm Ball Joint
Courtesy of SUZUKI OF AMERICA CORP.
Install the front exhaust pipe and centermember.
In case of manual transaxle vehicle, install the shift control bracket and clip.

Fig 3: Installing Shift Control Bracket
Courtesy of SUZUKI OF AMERICA CORP.
Install the steering interm shaft and bolt.
Tighten

Tighten the steering interm shaft bolt to 25 N-m (18 lb-ft).

Fig 4: Installing Steering Interm Shaft And Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the power steering pipe union nuts.
Tighten

Tighten the power steering pipe union nuts to 30 N-m (22 lb-ft).
Fill the power steering oil into the power steering system.