LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Verona S >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heater And Ventilation >> Repair Instructions >> Control Assembly Knob Lighting Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Assembly Knob Lighting Installation

  1. Install the bulb into the holder and turn the bulb to the right.
    Fig 1: Installing Control Assembly Knob Bulb
    G04095750Courtesy of SUZUKI OF AMERICA CORP.
  2. Install the control assembly case halves.
    • Pass the connector for the vacuum switch through the hole in the rear assembly case part.
    • Be sure to align the flats on mating control shafts of the two case halves.
  3. Install the connector into the vacuum control switch.
    Fig 2: Installing Connector Into Vacuum Control Switch
    G04095751Courtesy of SUZUKI OF AMERICA CORP.
  4. Install the control assembly. Refer to "CONTROL ASSEMBLY REMOVAL ".
  5. Connect the negative battery cable.
  6. Check the knob light for proper operation.
    Fig 3: Installing Control Assembly
    G04095752Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals