ATEQ TPMS Reset Procedure

NOTE: The TPM3 must be used with an SPX J-46079 or equivalent scan tool

NOTE: If spare tire has been used, or if a wheel or tire pressure sensor has been replaced, all 4 tire pressure sensors must be registered.

NOTE: The warning light may come on due to normal causes such as natural air leaks and pressure changes caused by changes in temperature or atmospheric pressure.

NOTE: In high altitude areas, the warning light may not turn off even after adjusting tire pressures. In this case, adjust inflation pressure to a slightly higher pressure than specified.

CAUTION: If warning light is still on or flashing after adjusting tire pressure and registering system sensors, there is a problem in the TPMS. See appropriate manufacturer service information.

Connect the scan tool with DLC connector.
Turn the Ignition switch to ON.
Go to the ID resister mode of the scan tool.
Contact the LF tool with the tire air valve and push the LF tool button for 4 seconds. The TPMS warning lamp will blink. Also you can see the ID on the scan tool screen.
Repeat step 5 for the remaining 3 tires, within 5 minutes.