P/S Pump Assembly Removal

Remove the serpentine accessory drive belt. Refer to "SERPENTINE ACCESSORY DRIVE BELT REMOVAL ".

Fig 1: Removing Serpentine Accessory Drive Belt By Turning Tensioner Bolt Using Wrench
Courtesy of SUZUKI OF AMERICA CORP.
Position a drain pan to catch the power steering fluid that will drain from the high-pressure hose after it is disconnected from the power steering pump.
Disconnect the high-pressure hose and the supply hose from the power steering pump.

Fig 2: Disconnecting High-Pressure Hose And Supply Hose From Power Steering Pump
Courtesy of SUZUKI OF AMERICA CORP.
Remove the bolt from the front right side of the power steering pump. Loosen the rear right bolt and swing the bracket out of the way.

Fig 3: Removing Bolt From Front Right Side Of Power Steering Pump
Courtesy of SUZUKI OF AMERICA CORP.
Remove the two long power steering pump bolts and remove the power steering pump from the vehicle.

Fig 4: Removing Power Steering Pump From Vehicle By Removing Long Power Steering Pump Bolts
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: The unit repair of the power steering pump in this vehicle is not serviceable.
A faulty pump must be replaced with a new one.

Fig 5: Placing Power Steering Pump In Vice
Courtesy of SUZUKI OF AMERICA CORP.