Steering Column Installation

Install the steering column shaft to the universal joint with bolt.
Tighten

Tighten the steering column shaft securing bolt to the universal joint pinch to 25 N.m (18 lb-ft).

Fig 1: Installing Steering Column Shaft To Universal Joint With Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the ignition switch retaining screw.
Tighten

Tighten the ignition switch retaining screw to 2.5 N.m (22 lb-in).
Connect the wiring to the ignition switch.
Connect the head amplifier connector, airbag connector and the other connector which are connected to steering wheel.

Fig 2: Installing Ignition Switch Retaining Screw
Courtesy of SUZUKI OF AMERICA CORP.
Install the steering column jacket assembly securing bolts and nuts.
Tighten

Tighten the steering column jacket assembly securing bolts and nuts to 22 N.m (16 lb-ft).

Fig 3: Installing Steering Column Jacket Assembly Securing Bolts And Nuts
Courtesy of SUZUKI OF AMERICA CORP.
Install the instrument cluster trim panel. Refer to "INSTRUMENT CLUSTER TRIM PANEL INSTALLATION ".
Install the knee bolster. Refer to "DRIVER'S SIDE KNEE BOLSTER INSTALLATION ".
Install the instrument panel under cover. Refer to "INSTRUMENT PANEL INSTALLATION ".
Install the steering wheel, turn signal switch lever and wiper switch lever. Refer to this article.

Fig 4: Installing Instrument Cluster Trim Panel
Courtesy of SUZUKI OF AMERICA CORP.
Install the upper and the lower steering column cover panel.
Tighten

Tighten the upper and the lower steering column cover panel screw to 2.5 N.m (22 lb-in).
Connect the negative battery cable.

Fig 5: Installing Upper And Lower Steering Column Cover Panel Screws
Courtesy of SUZUKI OF AMERICA CORP.