LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Verona EX >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Diagnostic Information and Procedures >> DTC P1840 EDS 3 Output Shorted to Power >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC P1840 TROUBLESHOOTING CHART

Step Action Value(s) Yes No
1 Perform an On-Board Diagnostic (OBD II) System Check.
Is the check completed?		 - Go to Step 2. Go to "ON-BOARD DIAGNOSTIC (OBD II) SYSTEM CHECK ".
2
  1. Install the scan tool.
  2. Turn the ignition ON, with the engine OFF.
  3. Select "Actuating" on the scan tool.
  4. Actuate the EDS 3 ON/OFF.

Does the EDS 3 change ON/OFF?		 ON/OFF Go to "DIAGNOSTIC AIDS ". Go to Step 3.
3
  1. Remove the oil pan.
  2. Disconnect the wiring connector of the EDS 3.
  3. Turn the ignition ON, with the engine OFF.
  4. Measure the voltage of the EDS3 wiring connector terminal 1.

Is the voltage within the values shown?		 11 - 14V Go to Step 4. Go to Step 5.
4 Repair the internal line (EDS 3) for a short to power.
Is the repair complete?		 - System OK -
5 Replace the EDS 3.
Is the replacement complete?		 - Go to Step 6. -
6
  1. Check if any DTCs are set.
  2. Are any DTCs displayed that have not been diagnosed?
 - Go to applicable DTC IDENTIFICATION . System OK
scientia non olet · About LEMON Manuals