DTC Troubleshooting

WARNING: The sensing and diagnostic module (SDM) can maintain sufficient voltage to deploy the airbags and pretensioners for 1 minute after the ignition is OFF and the fuse has been removed. If the airbags and pretensioners are not disconnected, do not begin service until one minute has passed after disconnecting power to SDM. Otherwise, injury could result.

WARNING: During service procedure, be very careful when handling the SDM. Never strike or jar the SDM. Never power the supplemental inflatable restraints (SIR) when the SDM is not rigidly attached to the vehicle. All SDM mounting bolts must be carefully tightened, and the arrow on the SDM must be point toward the front of the vehicle to ensure proper operation of the SIR. The SDM could be activated if it is powered when it is not rigidly attached to the vehicle, resulting in unexpected deployment and possible injury.

DTC B1333 - TROUBLESHOOTING

Step	Action	Value(s)	Yes	No
1	Confirm the ignition switch "OFF". Wait for a minute for the SDM charger to be discharged.	-	Go to Step 2.	-
2	Visually check any damage for the Early Crash Sensor Passenger (RH) wiring. Is the Early Crash Sensor Passenger (RH) wiring damaged?	-	Go to Step 3.	Go to Step 4.
3	Replace the airbag wiring.	-	-	-
4	Check the resistance between the terminal 72, 73 of the SDM connector and the terminal 6, 5 of the connector C213. Check the resistance between the terminal 5, 6 of the connector C213 and the terminal 20,19 of the connector C210. Check the resistance between the terminal 20, 19 of the connector C210 and the terminal E11, F4 of the connector C102. Check the resistance between the terminal F4, E11 of the connector C102 and the terminal C11, A4 of the connector C101. Is the resistance about 0 (zero) ?	10	Go to Step 5.	Go to Step 3.
5	Replace the Early Crash Sensor Passenger (RH).	-	-	-