LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Verona EX >> Repair and Diagnosis >> Body & Frame >> Glass/Windows/Mirrors >> Diagnostic Information and Procedures >> DTC 25 / 26 Power Window UP / DOWN Switch Error (Manual) >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

DTC 25/26 TROUBLESHOOTING

Step Action Value(s) Yes No
1
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the appropriate window switch parameter in the ISU Miscellaneous Inputs data list.

Does the scan tool display Inactive?		 - Go to Step 2. Go to Step 3.
2
  1. Activate the appropriate window switch.
  2. With a scan tool, observe the appropriate window motor parameter in the ISU Miscellaneous Inputs data list.

Does the wiper washer switch parameter change state?		 - - Go to Step 3.
3
  1. Turn OFF the ignition.
  2. Disconnect the driver window switch.
  3. Turn ON the ignition, with the engine OFF.
  4. With a scan tool, observe the window motor parameter.

Does the scan tool display Inactive?		 - Go to Step 6. Go to Step 4.
4 Test the signal circuit of the window switch for a short to ground.
Did you find and correct the condition?		 - Go to Step 10. Go to Step 5.
5 Inspect for poor connections at the harness connector of the intelligent switching unit (ISU).
Did you find and correct the condition?		 - Go to Step 10. Go to Step 8.
6 Test the signal circuit of the window switch for an open or short to voltage. Refer to short to ground.
Did you find and correct the condition?		 - Go to Step 10. Go to Step 7.
7 Inspect for poor connections at the harness connector of the window switch.
Did you find and correct the condition?		 - Go to Step 10. Go to Step 9.
8
NOTE: Perform the program procedure for the ISU.
Replace the ISU.Did you complete the replacement?		 - Go to Step 10. -
9 Replace the driver window switch.
Did you complete the replacement?		 - Go to Step 10. -
10
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?		 - Go to Step 1. System OK
scientia non olet · About LEMON Manuals