LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Swift + >> Repair and Diagnosis >> Transmission >> Manual Transmission Clutch System >> Repair Instructions >> Release Bearing Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Clutch Release Arm, Retaining Bolt & Nut
    GM1375131Courtesy of GENERAL MOTORS CORP.
  1. Remove the transaxle from the vehicle. Refer to Transmission Replacement in Manual Transmission - D16.
  2. Remove the release arm (2). Refer to Clutch Release Arm Replacement .
    3. Fig 2: Release Bearing
    GM1375133Courtesy of GENERAL MOTORS CORP.
  3. Remove the release bearing.
    4. Fig 3: Removing The No. 2 Bushing & Seal Using DT 47514 & A Hammer
    GM1375135Courtesy of GENERAL MOTORS CORP.
  4. Remove the release shaft and bushing.
  5. Remove the No. 2 bushing and the seal using DT 47514  (1) and a hammer. See Special Tools .
  6. Remove the release shaft (2).
    7. Fig 4: Threading Tap Into Bushing
    GM1375136Courtesy of GENERAL MOTORS CORP.
  7. Thread the tap (M16 x 1.51) (2) into the bushing.
    8. Fig 5: J 26419-01 & DT 47513
    GM1375138Courtesy of GENERAL MOTORS CORP.
  8. Connect J 2619-01  (2) to the end of DT 47513  (1). See Special Tools .
  9. Remove the bushing by pulling.
scientia non olet · About LEMON Manuals