Installation Procedure

Fig 1: Strut Assembly-To-Body & Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Care should be taken to avoid chipping or cracking the spring coating when handling the front suspension coil spring. Failure to observe this notice may result in spring breakage.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the strut assembly into the vehicle with the strut assembly-to-body nuts.
Tighten: Tighten the strut assembly-to-body nut to 60 N.m (44 lb ft).

Fig 2: Stabilizer Shaft, Control Arm & Control Arm-Link Bolt Assembly

Courtesy of GENERAL MOTORS CORP.

Connect the drive axle to the front wheel hub.

Fig 3: Stabilizer Shaft, Control Arm & Control Arm-Link Bolt Assembly

Courtesy of GENERAL MOTORS CORP.

Connect the outer tie rod to the steering knuckle assembly. Refer to Outer Tie Rod Replacement in Power Steering Gear orRack and Pinion Outer Tie Rod End Replacement in Manual Steering Gear.
Connect the ball joint to the steering knuckle assembly.
Install the ball joint-to-knuckle/strut nut.
Tighten: Tighten the knuckle to strut bolts to 100 N.m (74 lb ft).

Fig 4: Brake Caliper, Knuckle/Strut Assembly & ABS Speed Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the ABS speed sensor electrical connector, if applicable.

Fig 5: Drive Axle-To-Hub Caulking & Nut

Courtesy of GENERAL MOTORS CORP.

Connect the brake caliper to the knuckle/strut assembly. Refer to Brake Caliper Replacement in Front Disc Brakes.
Install the wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
Install a new drive axle-to-hub caulking nut.
Tighten: Tighten the drive axle-to-hub caulking nut to 300 N.m (221 lb ft).
Crimp the caulking nut sleeve onto the drive axle shaft.