LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Swift + >> Repair and Diagnosis >> Steering >> Manual Steering >> Power Steering System >> Repair Instructions >> Power Steering Pump Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the pump to the A/C compressor bracket and tighten the steering pump retaining nuts.

    Tighten:  Tighten the steering pump retaining nuts to 25 N.m (18 lb ft).

  2. Install the A/C compressor mounting bracket and tighten the bolts

    Tighten:  Tighten the A/C compressor mounting bracket bolts to 50 N.m (37 lb ft).

  3. Install the A/C compressor to the bracket. Refer to COMPRESSOR REPLACEMENT .
  4. Install the right side engine under cover.
  5. Install the right front tire. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
    7. Fig 1: Power Steering Fluid/ Pressure & Supply Lines
    GM1248373Courtesy of GENERAL MOTORS CORP.
  7. Connect the pressure and supply lines to the power steering pump.
  8. Install the right side engine cooling fan. Refer to COOLING FAN REPLACEMENT - ELECTRIC .
    9. Fig 2: Accessory Drive Belt
    G00563586Courtesy of GENERAL MOTORS CORP.
  9. Install the accessory drive belt.
    10. Fig 3: Air Cleaner Housing & Housing Bolts
    GM1248375Courtesy of GENERAL MOTORS CORP.
  10. Install the air cleaner housing with the housing bolts and the clamp.

    Tighten:  Tighten the air cleaner housing bolts to 12 N.m (106 lb in).

    11. NOTE: Refer to Using Proper Power Steering Fluid Notice .
  11. Refill the pump with new fluid and bleed the air from the system. Refer to Bleeding the Power Steering System .
  12. Inspect for leaks. If leaks are found, correct the cause of the leak and bleed the system.
scientia non olet · About LEMON Manuals