Sensor Learn Procedure
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Before proceeding with the procedure below, ensure that no other learn procedure is being performed simultaneously.
- Turn the ignition switch to ON, with engine OFF and apply the parking brake.
- Put receiver into TPM Learn Mode using Scan tool.
- Initiate the procedure by following the menu selections.
- If successful, double horn chirp sound and flashing low tire indicator(MIL) will indicate Learn Mode has begun.
- Within 2 minutes, go to the LEFT FRONT tire. Trigger the tire sensor to send a learn message (*use any method described below). If successful, a horn chirp is heard.
- After the horn chirp sounds, proceed as in step 3 for the next 3 sensors in the following order:
- Right front
- Right rear
- Left rear
- After the left rear sensor is learned, a double horn chirp will sound indicating all sensor IDs have been learned and low tire indicator (MIL) will turn off.
- If one of the tire sensors does not program within the 2 minute interval, the system will automatically exit programming mode and steps 2 through 6 must be repeated.
- If air was added or removed to trigger a tire sensor learn message, then the tire pressures should be adjusted to the correct placard cold tire pressures at this time.