LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Front Drive Axle) >> Repair Instructions >> Wheel Drive Shaft Outer Joint and Boot Replacement (Automatic) >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Large Seal Retaining Clamp With J 35566
    GM1242025Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive axle from the vehicle. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement .
  2. Remove the large seal retaining clamp using J 35566  (1). See Special Tools . Discard the clamp.
  3. Remove the small seal retaining clamp. Discard the clamp.
    4. Fig 2: Removing/Installing Outer Joint And Axle Shaft Snap Ring
    GM1242026Courtesy of GENERAL MOTORS CORP.
  4. Degrease the joint.
  5. Spread the snap ring using the J 8059  and remove the outer joint and the axle shaft. See Special Tools .
    6. CAUTION: The outer joint is designed to be replaced as a one piece unit. Do not attempt to disassemble or service the outer joint. Improper service will affect both performance of the vehicle and could cause personal injury or vehicle damage.
  6. Remove the seal from the joint assembly.
scientia non olet · About LEMON Manuals