LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Swift + >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Hydraulic Brake System) >> Repair Instructions >> Front Brake Hose Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Brake Caliper, Seal Rings, and Brake Hose
    GM1242049Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the new brake hose to the caliper with new seal rings and the bolt.

    Tighten:  Tighten the front brake hose-to-caliper bolt to 40 N.m (30 lb ft).

    2. Fig 2: View of Wheelhousing Bracket Brake Hose and E-Ring Retainer
    GM1242048Courtesy of GENERAL MOTORS CORP.
  2. Install the brake hose and the E-ring retainer to the wheelhousing bracket.
  3. Connect the brake line to the brake hose.

    Tighten:  Tighten the brake line to 16 N.m (12 lb ft).

  4. Lower the vehicle.
  5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) .
  6. Check the brake system for leaks.
scientia non olet · About LEMON Manuals