Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Blower Motor Switch & Knob Mount Support

Courtesy of GENERAL MOTORS CORP.

Install the spring and the electrical contact washer over the blower switch knob post.
Align the contact key with the post keyway.
Position the switch assembly over the mount posts.
Install the switch assembly with the screws.
Connect the electrical connectors to the rear of the control assembly.
Install the HVAC control assembly. Refer to Heater and Air Conditioning Control Replacement (Hatchback) or Heater and Air Conditioning Control Replacement (Notchback) .
Connect the negative battery cable.
Perform an operational check of the blower switch positions.