Installation Proccedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Spoiler

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: If reusing the rear spoiler, remove any remaining double-sided tape from the rear spoiler and the rear compartment lid.

Apply new double-sided tape.
Peel off the adhesive backing paper and affix the rear spoiler on to the rear compartment lid, ensuring it is carefully positioned.

Fig 2: Rear Spoiler Electrical Connector Inside Rear Compartment Lid

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the nuts attaching the rear spoiler.
Tighten: Tighten the nuts to 3 N.m (27 lb in).
Install the rear compartment lid trim with the clips.
Connect the negative battery cable.