LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2005 >> Reno S, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Rear Suspension >> Repair Instructions >> Knuckle Assembly Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Knuckle Assembly Removal and Installation: Installation

  1. Install the rear knuckle into the vehicle and install the brake line into the strut assembly bracket.
  2. Install the knuckle-to-strut assembly bolts and nuts. Do not tighten.
  3. Install the clip securing the brake line to the strut assembly.
    Fig 1: Installing Clip
    G04103136Courtesy of SUZUKI OF AMERICA CORP.
  4. Tighten the knuckle-to-strut assembly nuts.

    Tighten 

    Tighten the knuckle-to-strut assembly nuts to 100 N.m (74 lb-ft).

  5. Connect the rear trailing link to the rear knuckle. Refer to "TRAILING LINK REMOVAL AND INSTALLATION :".
  6. Connect the rear parallel link to the knuckle. Refer to "REAR PARALLEL LINK REMOVAL AND INSTALLATION :".
  7. Connect the front parallel link to the knuckle. Refer to "FRONT PARALLEL LINK REMOVAL AND INSTALLATION :".
  8. Connect the parking brake to the knuckle assembly. Refer to "PARKING BRAKE CABLE REMOVAL AND INSTALLATION :".
  9. Install the rear brake caliper, rotor, hub, parking brake shoe and back plate onto the knuckle assembly. Refer to "CALIPER REMOVAL AND INSTALLATION :"
  10. On vehicles equipped with the antilock braking system, install the ABS speed sensor. Refer to "REAR WHEEL SPEED SENSOR REMOVAL AND INSTALLATION :".
  11. Install the wheel. Refer to "WHEEL REMOVAL AND INSTALLATION :".
  12. Lower the vehicle.
    Fig 2: Installing Rear Knuckle-To-Strut Assembly Nuts And Bolts
    G04103137Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals